How to Use 12 inch circular saw

What's the best thing about using a circular saw?

One of the good things about using a circular saw is that you can angle the blade to make bevel cuts. However, one issue is that the blade guard can catch on the wood as you start your cut. To prevent this from happening, hold the blade guard up until you get an inch or two into the cut.

How long does it take to make a circular saw?

It takes about an hour to build this circular saw rip guide. Cut the plywood base and pieces carefully to make sure they have parallel sides and square corners. Make the slots and the hole for the blade and blade guard by first drilling 3/8-in. holes in the corners and then cutting between them with a jigsaw.

When to use 45 degree angle on circular saw?

It corresponds to the position of the blade when it's set to 90 degrees, and should be used any time you’re making a normal cut. The line labelled "45" on the righthand side of the notch is for making beveled cuts at a precise 45-degree angle. Activate the saw blade by pulling the trigger on the rear handle.

How big of a piece of wood can you cut with a CIRC saw?

Probably the most common use for a circ saw on construction sites is cutting a 2 by 4 or 2 by 6 to length. You need to cut a piece that’s 14-1/2 inches long from a piece that’s maybe 20 inches long, so you make a mark on the wood at 14-1/2 inches and set your saw in position so it will cut there.

Share

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *