How to Use 16 circular saw

What's the best thing about using a circular saw?

One of the good things about using a circular saw is that you can angle the blade to make bevel cuts. However, one issue is that the blade guard can catch on the wood as you start your cut. To prevent this from happening, hold the blade guard up until you get an inch or two into the cut.

How long does it take to make a circular saw?

It takes about an hour to build this circular saw rip guide. Cut the plywood base and pieces carefully to make sure they have parallel sides and square corners. Make the slots and the hole for the blade and blade guard by first drilling 3/8-in. holes in the corners and then cutting between them with a jigsaw.

Can a circular saw cut through a 6 by 6 post?

a circular saw can’t cut through it all in one pass. If you want or need to use a circ saw to shorten a 6 by 6. post, which is actually 5-1/2 inches on a side, you must make a cut into one face, then rotate the post 90. degrees, make another cut, rotate, cut, rotate and cut.

What should the depth of a circular saw be?

If you’re sawing a piece of lumber that’s 1 in (2.5 cm) thick, for example, you’d set your blade to a depth of 1.125–1.25 in (2.86–3.18 cm). Setting the saw blade to the correct depth will ensure cleaner cuts and reduce friction, which can wear down the teeth and leave imperfections in the surface of your material.

Share

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *