How to Use 16 inch circular saw

What kind of cuts can you make with a circular saw?

Push the blade through the cut and let the pieces fall. Release the saw trigger and let the blade come to a full stop. Most cuts you make with a circular saw will be crosscuts or rip cuts. A crosscut goes across the grain of the wood, and a rip cut goes with the grain.

How long does it take to make a circular saw?

It takes about an hour to build this circular saw rip guide. Cut the plywood base and pieces carefully to make sure they have parallel sides and square corners. Make the slots and the hole for the blade and blade guard by first drilling 3/8-in. holes in the corners and then cutting between them with a jigsaw.

What should the depth of a circular saw be?

If you’re sawing a piece of lumber that’s 1 in (2.5 cm) thick, for example, you’d set your blade to a depth of 1.125–1.25 in (2.86–3.18 cm). Setting the saw blade to the correct depth will ensure cleaner cuts and reduce friction, which can wear down the teeth and leave imperfections in the surface of your material.

How big of a piece of wood can you cut with a CIRC saw?

Probably the most common use for a circ saw on construction sites is cutting a 2 by 4 or 2 by 6 to length. You need to cut a piece that’s 14-1/2 inches long from a piece that’s maybe 20 inches long, so you make a mark on the wood at 14-1/2 inches and set your saw in position so it will cut there.

Share

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *