how to use a gas pull saw

How do you use a gas pole saw?

The steps below lay out how to use a gas pole saw. As you hold the grip of your pole saw and make a balance of your position, make few a jump cuts underneath the branch you want to cut off. Jump cuts are a necessary technique which is used before the final cut. It reduces the weight of the branch that makes the final cut easier.

When do you need to use a pull saw?

You probably won’t need a pull saw every day, but it’s a great tool to have when the need arises. Unlike Western-style saws, which cut on the push stroke, Japanesestyle saws cut on the pull. Pulling on the blade takes advantage of steel’s higher tensile strength compared to its compressive strength.

What's the best way to use a gas chainsaw?

How to Use a Gas Chainsaw 1 Make your cuts away from the bar tip. ... 2 It's good practice to cut at waist level — never above shoulder height. 3 Avoid cutting too close to the ground where the blade could dig in and kick back. 4 Try to cut from the side of the saw — never while hovering over the work area. ... More items...

How to start a gas saw with a cold engine?

Starting the Gas Saw. 1 Step 1: Engage the Chain Brake. To start a gas chainsaw with a cold engine, place it on flat ground. Push the chain brake forward until it engages. 2 Step 2: Set the Choke and Prime the Gas Engine. 3 Step 3: Brace the Saw and Pull the Starter Handle. 4 Step 4: Start the Gas Saw.

Share

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *