How to Use circular saw workbench

Can a circular saw be used as a workbench?

The saw has to be squared up with the front edge of the workbench, so I need to measure twice before cutting. Making the Opening. Then again, I drilled 4 holes for the jigsaw blade to pass through and made an opening as big as the circular saw.

What's the best thing about using a circular saw?

One of the good things about using a circular saw is that you can angle the blade to make bevel cuts. However, one issue is that the blade guard can catch on the wood as you start your cut. To prevent this from happening, hold the blade guard up until you get an inch or two into the cut.

How long does it take to make a circular saw?

It takes about an hour to build this circular saw rip guide. Cut the plywood base and pieces carefully to make sure they have parallel sides and square corners. Make the slots and the hole for the blade and blade guard by first drilling 3/8-in. holes in the corners and then cutting between them with a jigsaw.

How does the base plate work on a circular saw?

Base-plate/ shoe - Allows you to set the depth of cut by exposing more or less of the blade. Trigger - Unlike other power tools, a circular saw has only two speeds; on and off. As soon as the trigger clicks the motor is trying to bring the cutting blade to full speed. Always give the saw a few moments to reach top speed before you begin your cut.

Share

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *