how to use line guide on circular saw

What's the best way to line up a circular saw?

Having too much blade exposed is not only dangerous, but it increases the likelihood of a messy cut. A speed square is the best way to line up your cuts when you just need to make a quick, short or freehand cut. Line the guide mark up to your line, and place the square to the left side of the saw’s shoe, as shown.

How long does it take to make a circular saw guide?

Two guides took about an hour to make, and that included a coffee break. Zero clearance. The guides will prevent splintering on one side of the cut. Place directly on cut line. With many circular saw guides you have to accommodate the distance from the fence to the blade.

Can a circular saw be used to cut a hole?

You can use a circular saw to cut holes out of the middle of a sheet of wood, but it requires a steady hand and a little practice. Set the blade to the correct depth and align the guide mark with your cut line. Hold the blade guard back slightly while you tip the saw forward on the toe of its shoe.

What are the operating procedures of a portable circular saw?

C. Portable Circular Saw Operating Procedures 1. Select the correct blade for the type of cut being made and the type of material being cut. 2. Adjust the saw base so the blade extends through the material being cut by no more than 1/4" 3. Mark material so that a good visible line is present to help guide the cut. 4.

Share

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *